Site monitoring
Supported measurements can include PV generation, battery state of charge, site load and grid flow, with the available history and export fields confirmed per platform.
EMS & monitoring
Energy management & monitoring for your system
For projects using Hithium storage and Growatt WIT three-phase C&I hybrid inverters, monitoring and energy-management functions are configured around the site design. Peak shaving, self-consumption, tariff scheduling and remote support depend on the selected equipment, firmware, interface permissions and local project requirements.
Discuss EMS integrationFunctions assessed for each project
Peak shaving & load control
Peak-shaving thresholds and discharge limits are set from the approved site load and grid-connection design; response behaviour is validated for the selected hardware and controls.
Tariffs & external price signals
Tariff schedules or external price signals can be used when the selected platform, data feed and write permissions support them.
Self-consumption optimisation
Project logic can prioritise storing and using on-site solar while respecting battery, inverter and grid-export limits.
Alarms & remote support
Available alarms and remote diagnostics depend on platform accounts, connectivity and the service scope agreed for the project.
Cost & sustainability data
Available generation, self-consumption and grid-use data can support cost and sustainability reporting; report fields are confirmed per integration.
Platforms & integration
Sunket Supply coordinates the Growatt WIT C&I hybrid inverter, Hithium battery and site-monitoring interfaces. Available protocols, data points and control permissions are confirmed for the selected model, firmware and project design before order.
Growatt platform & access
Growatt monitoring is available for supported WIT configurations. The applicable cloud service, account region, user roles, data access and retention terms are confirmed per project.
C&I hybrid inverter control
The Growatt WIT three-phase C&I hybrid inverter provides project-configured operating modes and power limits. The command set depends on model, firmware and system design.
Third-party EMS & safety boundary
Third-party EMS integration may use documented interfaces such as Modbus. Writable registers, command scope, polling requirements and any gateway are confirmed per project; BMS, inverter and site-protection limits remain authoritative.